In dry hose hoisting, which action creates the initial fold of the nozzle?

In dry hose hoisting, which action creates the initial fold of the nozzle?

• A. Fold nozzle end of hose approximately 4-5' back on itself
• B. Tie a clove hitch over the nozzle/hose so that they are lashed together
• C. Finish with half hitch about 12" from the loop end
• D. Use hose as tag line to keep from bouncing against building

Answer: (A)

Creating the initial fold in the nozzle by bending the nozzle end back on itself about 4–5 feet gives you a controlled, doubled section that acts as a grab point. This folded end forms a manageable handle and helps prevent the nozzle from whipping as the hose is hoisted, making the ascent smoother and reducing snag risk. It also sets up a stable point for subsequent lashings or tying steps to secure the nozzle to the hose, which are done after this fold. Using knots or using the hose as a tag line are actions that come later and don’t establish the initial control point needed to start the hoisting process.

Creating the initial fold in the nozzle by bending the nozzle end back on itself about 4–5 feet gives you a controlled, doubled section that acts as a grab point. This folded end forms a manageable handle and helps prevent the nozzle from whipping as the hose is hoisted, making the ascent smoother and reducing snag risk. It also sets up a stable point for subsequent lashings or tying steps to secure the nozzle to the hose, which are done after this fold. Using knots or using the hose as a tag line are actions that come later and don’t establish the initial control point needed to start the hoisting process.